Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have some legacy Cisco 6513 switches with the backbone (16-port GBIC blade) MTU set to 1500. It has a WS-X6148A-GE-TX blade as well, MTU set to 9K.Now we have a customer sending MTU of 1546, their copper interface terminating on WS-6148A keeps...
Hi,Im trying to connect a Cisco 2811 using an octal cable to a Juniper MX480 console port. (Sorry for mentioning Juniper)Since the distance between Cisco 2811 and router is 20ft, im using couplers and a straight-through cable for the lack of slack. ...
Hi,I was working on adding a Cisco 6513 to TACACS but ran into trouble. While I work on the issue offline (recreate and test another switch), I wanted to place this switch on radius temporarily.For some reason i cant undo/delete the AAA commands in ...
Hi,I have a Cisco 6500, reshuffled the cards around but now I have slots 5 and 6 as 24-port SFP blades however these slots are physically empty. I need to do some house cleaning but dont know how to reset or clear what was in slots 5 and 6. Let me ...
On the Cisco 2811, Im using an octal cable. This provides 8 rollover cables. I used two couplers and a striaght-through for the reach. Cisco 2811=>octal "L4" (female connector)=>coupler=>straight cable=>Juniper console. Should i use a roll-over i...
Hi Kevin,I tried. After unable to remove via vty, it was performed via console with no luck. Console access is on the active SUP. However, i still cant remove the command.Mn
Just attempted on the standby but getting a standby console disabled. Not sure what to do next without erasing the start-up, then reloading, since i have a customer on this switch.-Mn
Not sure on the response but here is the line con 0 config:line con 0 exec-timeout 5 0This was done before anything. I wanted a 5 minute timeout of console to ensure no active session with console. This was attempted several times by logging out th...
