Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am managing wireless network in a convention centre which has almost 2000 APs and 28 WLCs. RF ID and location tracking enabled. In WLC I can see 500+ rogues getting detected in each WLC in different mac address. Few of these mac I can trnasilate in...
I have a customer using 1250 AP with monopole antenna, he face frequent disconnection for voice clients during roaming. Phone is forced for reregistration to call manager during the hand off. Same customer has dipole antenna in a different floor with...
4400 wont be supported for new AP platforms starting from 3600. Best bet will be to go with 5500. 3500 and 3600 both support clean air functionality. You have to pay a very high premuim for the clean air technlogy. If you have a budget constarin and ...
Atlast cisco conformed this is a bug in WLC code. CSCtr91576 AP 3502 in Monitor mode reports false rogues. Initially cisco pointed a possible fake AP attack in the network and later (after 4 days ) they corrected it as a bug in their code. We had sp...
What is the security you are using in the wlan ?If it is dot1x based, chack the logs in the ACS to understand the reason for failure. If you dont have access to ACS, enable "debug client " command in the WLC and see in which phase the authentication ...
Roy,Rogue means any wireless device not managed by your WLC which comes inside your AP coverage area. Same mobility group and samd RF group name is an exception. So detected rogues not necessarily be in your wired network. There are multiple options...
You can use 1240 or 1250 autonomous AP in workgroup bridge mode. Using workgroup bridge u can connect to the WLC and other interface can be configured as root so this will provide you an option to server the clients as well as manage them using your ...