Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a lot of client in one configuration who have problem with the message:EAPOL-key M2 with invalid MICConfig:4402-12 in 4.1.171.0 (and ER) sw releaseAP1242 with 2 4941 in diversity modeSSID in WPA-TKIP PSK and DHCP on the WLC.A lot of client can...
Hi,I have a WCS in 4.1.83 and 3 WLC 4404-2 12AP in 4.1.171.0 (ans ER).I'm think that the update of information between WLC to WCS are too slow. The update is about inforamtion, like client associated, ....Do you know if it's possible to change the up...
Hi,I have co convert ap from autonomous to ligh and i have to migrate the configuration and i don't know how in this case.The client make 1 SSID with 2 differents auth method:"dot11 ssid PROD authentication open eap eap_methods authentication ne...
Hi have the same comportement, and i found one issue, not a very good issue, but an issue ..... When your PC is in VLAN2, you try to connect in ssh or https to the controler with the WLC IP oin vlan2 (192.168.2.x) and ... it's not work-> ok, immedial...
Hi,I'm do-it and it's working fine. the QoS is ok, but cisco say's that's VOIP with 7920/7921 is not supported on Mesh network. (not supported by TAC). But it's working.In the futur Cisco whant to do a lot of echencement for officially spport the TOI...
be carfull, you can't connect directly ASA5510 and WLC4400, the speed of the WLC4400 is only 1G and not 100M like interface of the ASA. TYou must use a switch or ASA5520 with gigabit interface.
