Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Basically what am I trying to do is establishing a PPPOE connection from our FW to Cisco 878, and get the public IP to the untrust interface of the FW. The interface of the FW of PPPoE(SSG520 - Netscreen) is quite simple..But on the 878 bridgin...
16 -> 255.255.0.022 is for subnet 255.255.252.023 -> 255.255.254.024 -> 255.255.255.032 -> 255.255.255.255255 - 252 = 3 thus gives you 3 more networksso the ip range will be172.16.210.1 to 172.16.213.254172.16.210.0 -> Reserved for network adress (Do...
...and a VLAN for nat inside?!interface Vlan1 description INSIDE ip address 10.0.0.1 255.255.255.0 ip nat inside ip virtual-reassembly ip tcp adjust-mss 1452 hold-queue 100 out!more info:http://www.cisco.com/en/US/products/hw/routers/ps380/products_c...
Which model are you using? Cisco 870 series??Depending to the model you may need to create VLAN and "ip nat inside" to this interface so the Network translation may occur.#Other than that my 878 need a DSL controller config for the g.shdsl connection...
