Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm working with a Catalyst 3650, using PuTTY as the terminal interface. I installed a new ios image on friday due to an accidental deletion of the original image from flash (it's now monday). Connection via console cable was working fine on fri...
I accidentally deleted some of the startup images from the flash on a Cisco Catalyst 3650. I am going through the steps of transferring a new ios image using a serial cable and extraputty, however when I get to the transfer portion, the switch begins...
I wish I had more to add than this , but after power cycling 3 times in a row, holding mode to stop regular boot then power cycling and letting it start up normally, the CLI started working again. This was after again connecting it to an HPE switch t...
---- Posted reply in wrong thread (thread I was viewing rather than thread I meant to reply to) ---- deleted post content here as it is not relevant here and was not intended for this thread. My apologies for bumping an old thread
Hi Balaji, I do not have an ip address set yet, as I had just re-flashed the ios on friday and hadn't done any additional setup yet, which is why I'm wondering if someone has gone wrong with some of the software. Switch hasn't been moved since Frida...
Hi, Thanks for your reply. I was able to use a USB to boot from and then transfer the bootable image to the devices internal flash storage and recover the system. The switch was a dark gray Catalyst 3650. Incase anyone is looking here in the futu...
