Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've noticed that when randow-seq is enabled, about 10% connections failed.I've encountered the same effect on version 2.3 and 3.2.Any suggestion about what could be the causes of such behaviour ?Frans
After upgrading IOS 12.2SXD ->12.2SXF on both 6500, the CSM 4.1(6) displays the following message :router#sh MODULE CSM 8 FTFT group 1, vlan 930 This box is active Configuration is out-of-sync priority 110, heartbeat 1, failover 3, preemption is offA...
When upgrading fwsm from version 2.3 to 3.2, is the running activation key" (multiple context) automatically imported into the new version?Or do I have to key the number after reboot ?Thanks for your helpFrancois
The release note for ios SXH, indicates that the CSM turns off when activated on that release. But, says also that the releases corrects CSM bugs from previous version...Could you explain the point ?Thanks for your helpFrancois
During upgrade from 2.3 to 3.2, is the running activation key automatically imported into the new version ?Or do I have to key it from the new version.Thanks for your commentsFrancois
May I assume that the serverfarm "route" and vserver "route" must be configure in addition of the serverfarm "PROXY_WAP2_PLES" and vserver "PROXY2_PLS_80"? And furthermore, may I assume that by default the fragmented packets will be correctly forward...
Hi Gilles,The new tests I made using the following client source addresses :10.143.146.2110.143.146.2710.143.146.3010.143.146.12... result in a SINGLE server in the serverfarm targeted by the CSM (configured with "hash source address").I've triggered...
Thanks Gilles,Is there a way to simulate the algorithm "hash source address" ?My sources addresses are :10.64.5.13810.64.5.14410.64.5.150Thanks for your helpFrancois
