Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I know this is quite simple, but the end result continues to elude me..I have two LAN's, 192.168.0.0 (A) and 192.168.100.0 (B). I need the hosts on (B) to talk the servers on (A). I have a Cisco 2801 Router. From (A) I can ping the interface configur...
Hello, I am new to Cisco routers and I have a 2801 unit here I would like to setup for static routing. I have two firewalls, both Watchguard x core units. One is configured on a DSL connection, the other on cable. I want to route all traffic destined...
Had to walk away from this yesterday. Came in today, reset to factory and started over. I can still ping each router interface from both subnets, but still cant ping hosts.Building configuration...Current configuration : 1335 bytes!! Last configurati...
Standard IP access list any 10 permit any (4139 matches)Standard IP access list oubound0/0 10 permit 0.0.0.0, wildcard bits 255.255.255.0Standard IP access list outbound0/1 10 permit 0.0.0.0, wildcard bits 255.255.255.0Extended IP access lis...
I know this is simple stuff..I can ping both router interfaces from both subnets, all routes are in the windows routing tables, but STIll cant ping hosts behind the router. errrThanks for all the help, very appreciated
Ok, here is my new config, still cant ping hosts on B...Building configuration...Current configuration : 1612 bytes!version 12.4service configservice timestamps debug datetime msecservice timestamps log datetime msec!hostname itfroute01!boot-start-ma...
