Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I read lots of articles and manuals, but I can't make netflow work correctly.I read conversation about NetFlow http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Ddis...
I have a Catalyst 6506-E SUP 32.I want to use a web interface to manage this device.I have got following files:cvdm-c6500-1.1.tar (Engine)cvdm-c6500chassis-19.0.tar (Chassis)and it's manuals.Manuals say that these interfaces don't support Super Eng...
Hi! This forum is my last hope to get replies for my questions.I have a Catalyst 6506-E:1 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX 2 48 48-port 10/100/1000 RJ45 EtherModule WS-X6148A-GE-TX3 3 Network Analysis Module ...
I found out that I already have got a patched IOS. It's version is Version 12.2(18)SXF6, RELEASE SOFTWARE (fc1). But the bug presents.I remove all nat from configuartion and I managed to enter:mls ip flow interface-full
My Cat doesn't accept following:mls flow ip interface-fullIt replies^% Unable to configure flow mask for ip protocol: full. Reset to the default flow mask type: noneBut I remember that once time I managed to enter this string.Yeah. I have Sup 32. ...
