Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My current setup is as such:Client -> 2811(SSLVPN) -> PIX -> LANI am currently able to connect to the 2811 and get an sslVpn connection, however I am unable to see the lan beyond the pix. I'm assuming there is an access rule that I must define in ord...
I am trying to configure a new router for a new internet connection. I was given the following information from the ISP:Connected point to point ip:X.X.1.28/30Default gateway:X.X.1.29/30Routed network IP:X.X.3.224/28Now, using the above info I was ab...
I have PIX 515 that I am trying to get to point out to the internet through a 2811.I can get to the internet through the 2811 if I connect directly to the router, however through the PIX I'm running into some problems.Router Details:Internal IP:192.1...
I have PIX 515 that I am trying to get to point out to the internet through a 2811.I can get to the internet through the 2811 if I connect directly to the router, however through the PIX I'm running into some problems.Router Details:Internal IP:192.1...
We are in the proccess of dropping our T1's and replacing them with a fiber drop that has been installed in our building. I have been given the handoff from the ISP and have the router in hand.After "configuring" the router I am able to trace/ping/et...
First off, thanks for the help Jon, much appreciated. Second off, I cannot ping the private 192 address, however I can ping the public X.X.3.225 address. I'll give debugging a shot and see if I cant get some more info.Thanks again.
I have a default rule that allows all inside traffic out, this includes telnet. I can telnet into smtp servers, etc. outside the router.I just cant telnet into the inside interface of my router.That interface has two IP's:a private address: 192.168.2...
I had no access-list on the pix to allow ICMP back in. Thanks for the heads up.Now I have a seperate problem:I cannot telnet into my routers internal interface from behind the firewall. Any thoughts on what might be causing this?
