Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Heyi establish a site to site VPN between 1 CISCO ASA 5510 v8.4 but i can only ping between SITE A 192.168.200.0 and 192.168.100.0. I cannot ping from 10.0.0.0 to 192.168.100.0 from SIT EA....what is wrong with my config? does the ACL and object-grou...
Hello im trying to establish an ipsec tunnel between 2 ASAs 8.4 with no luck, but i dont seem to find out what is missing Can someone check if my configuration ts ok? i SITE AObject-group network COMPANY-ANGNetwork-object 192.168.100.0 255.255.255.0N...
HiIs it possible to use remote VPN with DRAYTEK knowing that the PUBLIC IP is delivery on a CISCO ASA on Ethernet 0/0 interface?The CISCO ASA is conected to internal LAN 192.168.245.0/24 and i want to be able to access internal network from OUTSIDE l...
HelloI have a site-to-site VPN running between 2 cisco ASA. Everytime the connection drops, i have to restart the FIREWALLs to bring up the tunnel again.Is there way to maintain the connection even if drops (ex: failed WAN connection).Plus, i cannot ...
Hey We changed the PUBLIC IP in one site...and now we are trying to establich new IPSEC TUNNEL between both sites (CISCO ASA 7.2 - it was qworking before public IP change) .I was able to establish the tunnel but i cannot ping both ends\remote networ...
HelloI found out, if i put the generic NAT rule at the TOP of the configuration, it blocks PING between sites....if i change the order (NAT exempt first and than generic NAT rule) everything works Is this make any sense? That is my running config wo...
HiI was able to establish the VPN connection ....but now, i cant ping local networks across the tunnel.im tryng to ping from a PC with ip 192.168.100.66 to a PC with IP 10.0.0.66 on SITE A and from 10.0.0.66 to 192.168.100.66None of them reply to pin...
Hey thank you for the reply i changed the nat rule but i didn't work, plus when an issue the command "sh crypto isakmp sa" the tunnel is not even trying to associate...something wrong beside the nat rule? SITE B FULL CONFIGciscoasa# sh crypto isakmp ...
HeyWe have one ASA in each site establishing the TUNNEL VPN Config: SITE Aaccess-list outside_20_cryptomap extended permit ip 192.168.100.0 255.255.255.0 192.168.200.0 255.255.255.0access-list outside_20_cryptomap extended permit ip 192.168.100.0 255...
Hey Thanks for the reply We added the new public IP on different interface (internet is working) of the ASA and disabled the old interface, than we runned the VPN WIZARD to establish the new connection with local and remoted networks added. We can pi...
