Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I removed a static nat entry. I cleared the xlate table - within seconds the static translation for the entry I had just removed was back.The firewall did not remove the entry from the translation tableDespite the fact that there is a command 'clear ...
Hello,We are having a problem with our pix not accepting VPN Client connections.We have recently upgraded to 6.3 and enabled the 'isakmp nat-traversal 20' feature. Its works with UDP encapsulation and has been working for about a month now. But all o...
Is there going to be any comprehensive documentation released on version 4.0 of the IDS sensor?The is no documentation on this new RDEP protocol or the architecture of the device. Quite honestly, the documentation is really shoddy for version 4.0.Qui...
Hello,Multiple clients are behind a PAT device which is a GPRS router.Despite the fact that they have enabled 'transparent tunneling' using 'UDP encapsulation' - only one of them can connect successfully behind the device. I have already tried to fo...
Hello,I have a pix which someone else configured.The person configured the ip local pool to use a range of addresses which resides on the same subnet as the inside of the firewall.Lets say the inside subnet is 192.168.5.1-254 /24 and the person has u...
No - I did this:no static blah blah blahsh xlateclear xlate blah blahclear xlatewr memreload<< ONCE REBOOTED ... GONE>>Do you think I should have done a write mem and then checked the x-late table?Why would it make a difference?
