Hello experts...I've had a set of PIX 506E boxes holding an IPSEC tunnel for a good year or so without a hitch. Today, the tunnel dropped and I lost access to the remote site. The local PIX can only ping devices on the local [inside] subnet and all n...
Hello. I'm having a small dial-peer issue for outbound international calls in CME. The dial-peer is as follows:dial-peer voice 5 pots destination-pattern 9011T port 0/1/0:23 forward-digits 11 prefix 011You can see off the bat that the number of digit...
I have completed an installation of CME 4.1 / CUE 2.3 and have everything running just the way I want it (almost) -- then I noticed all incoming voicemails that are left on a user's mailbox say they are from that same extension. For example, a calle...
How can I get the full 10-digit originating number to show up during outbound calls? Right now, the dialed number on PSTN side gets the 4-digit extension.This should be an easy one -- I've done this many times on CCM, 1st on CCME.Thanks,Jad
Hello experts,This is a new small office VoIP setup utilizing a 2851 Integrated Services router. System is fully configured and working for the most part -- internal and local outbound calls work as well as incoming calls. I have 2 dial-peers for o...
Andy, I also have FIOS and I'm trying to do a similar config with a PIX 506E plugged into Verizon's modem. Did you use your DHCP-assigned IP on the ASA's external (internet-facing) interface? Is the ASA plugged directly into the modem's switch?Thanks...
Brandon, that's for the response. That is one of the first things I tried. Unfortunately, if I do a "no forward digits 11", it automatically populated it with "forward-digits 0". Then the only thing being passed is the prefix (011).Jad
Thanks for the response. I have tried several different switch types with no luck. Telco's switch is a 5e using NI configuration/compatibility...so I tried both and some others. They're side is identical to several other clients running voip, whic...
I removed both of those with no change. I think i'll leave them out since they don't need to exist.Right now i've managed to get Unity to say "Message 1 from unknown caller". This is better than stating the local extension. This was accomplished b...
