Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, We have replaced our PIX with ASA 5510 and are running, ASA Version 8.3(1) & asdm-631.bin. We have 1 ASA and 2 WAN's. So I have configured Failover, so that if primary WAN fails secondary will be active, which works fine. Only problem is NAT...
Hi, I am bit confused. We have 2mbps leased line and have Cisco 1841 which is managed by our ISP. I have hooked up another 1841 (please find basic config below, it will get more complex lateron) Now when I connect my laptop I am able to browse Inte...
Hello, I guess this has been asked in past, but I need some help. I was suggested that we use following config. I want to know, your opinion, before I install this 1841 So we have 2 megabits/sec (up&down) leased line and we want to allocate 1mbps...
Hello, Apart from,no ip nat service sip tcp port 5060no ip nat service sip udp port 5060 is there any way to disable SPI on Cisco 1841. Basically we are just using it for hosted VOIP Phones (no data traffic), which connect to hosted phone pro...
Hi pkampana, What happens is, when I have these rules (in the order in my previous post) and if I am on WAN1, then the 1st match in the list will work. ie.object network NTSERVER02-WAN1nat (any,any) static 83.244.238.164 So only host NTSERVER02-W...
