Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have two Cisco ASR-1002-X work as BNG for pppoe subscriber and i run CGNAT on it when i run ip nat log translations syslog on both of them one of BNG log all NAT and the other BNG miss a lot of nat session and show only few of them my syslog config...
hello we have cisco ASR1002-X and we try to upgrade it to asr1002x-universalk9.16.06.07.SPA after we restart the router it enter in restarting loop and show this messages now i can't do anything to router Initializing Hardware ...
System integrit...
hi all I have nexus 3064 and the downlink is trunk port-channel and there are many VLANs pass through this port-channel and each VLAN carry different service can is there any way to monitor the traffic of this VLANs ?
Hi guys I have 4 ASR 1002-x acting as PPPOE server i upgrade three of them to asr1002x-universalk9.16.09.07.SPA.bin and Rommon to 16.7(1r) as recommended in https://www.cisco.com/c/en/us/td/docs/routers/asr1000/rommon/asr1000-rommon-upg-guide.html#...
Hello I run QOS to police youtube traffic and use cbQosCMPrePolicyBitRate (1.3.6.1.4.1.9.9.166.1.15.1.1.11.) OID to monitor the amount of youtube traffic in PRTG software , the issue is when the traffic Exceed 4300 Mbps the router stop send the rig...
this 10000 is the maximum rate that i can configure this show from the BNG that doesn't has any issueR1#show loggingSyslog logging: enabled (258254952 messages dropped, 2809053169 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering ...
no it was the same after this but i say the PPPOE session remain connected but some websites are open and some stopped i found the solution it was NAT issue after i applied the below configuration it has been fixed ip nat translation timeout 500
i...
