Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured a active/standby pair but am having one last issue on the configuration. The active unit appears fine and shows the correct status when performing a 'show failover'.As for the standby I am unable to login into the system since the e...
Hello.I have a cisco ASA5505 and am unable to login to it via http or asdm... The device is up and operational but remote access isn't available. Are there any steps i can take to restart the remote access services without rebooting the device itself...
Hello.Attached are the outputs from the standby and active asa's. To note. To actually gain access to the standby, i had to disable the failover, reboot the standby asa then re-enable the failover. After i gained access to the system , and gained the...
I can only run these commands on the active asa as i am unable to login into the standby. I am attempting to connect via the IP 172.16.101.2 which works fine when the standby device has been rebooted with it's external interface cable unplugged. For ...
