Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I'm quite new to Cisco networking, but not to networking as a whole.We've recently had a production area covered with 5 x AP1141N which are controlled by a 2112 Wireless Controller, it provides a single WLAN for the area.In an effort to unde...
I about to embark on a project to create a wireless bridge using a pair of Cisco Aironet 1252's, which will be mounted internally, and a pair of Cisco Aironet 5-GHz MIMO 6-dBi Patch Antenna (AIR-ANT5160NP-R), which will be mounted externally.Could an...
Hi there,We're planning to connect a building no more than 50m away to our network via wireless (after careful research. The builing will only house 2 people, one requiring just internet and email access for ordering materials, the other will be doin...
The buildings are laid out as shown in the little diagram attached - the red buildings are the ones we have acquired and will require network access. The other building as about 60m away, max based on the angle from the proposed antenna.Hopefully won...
Thankyou for your advice.The problem we have is that we'd like to expand the system in the future to connect another couple of sites and as such (maybe I read your post wrong) we decided that 54Mbps would not allow for sufficient bandwidth.We'd like...
Well, here's a picture of both locations. Unfortunately, the brick part of each building is too low and has obstructions like chainlink fences and trees. Would mounting it on a pole extending from the main building be sufficient to reduce reflection?...
