Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys.I hope you are doing fine. Our infrastructure is being audited by an auditor and they asked us to provide a proof which shows FTDs (We are using Cisco Firepower 2100 series) use SSH version 2.I looked everywhere in order to find out about the...
Hi Guys.I hope you are doing well. We have a pair of FTDs (2100) in Active/Standby mode. We created a port-channel on them which includes 2 electrical interfaces (Copper). Due to some decisions, we want to change this port-channel to use optical conn...
@Mike.Cifelli Thanks for your answer.I have also searched a lot in this regard but I could not find anything useful.But I think Marvin's solution helps in this case.
@balaji.bandi Thanks for your quick response. According to this article, I found out that I cannot put a RJ-45 and a Fiber in to an etherchannel on FTDs. Best,Peyman
@balaji.bandi Yes I want to replace two copper ports with two fiber ports.I was not sure if I can add ports of different media (Fiber) to the current ether-channel (Copper) and use them.Considering that the fiber cables are not connected at the momen...
