Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
according to ISE Wired Deployment Guide. automate-tester command isnt needed as the switch by default dosnt have a deadtime (default 0 so always up) however we have this in there confgured as per the below; i am going to add the "ignore-acct-port" a...
hi Walker, reload works around the issue for us too,however not recovering from a dead server still, what version did you upgrade too please as we are on 17.3.6. our MAB config was upgraded a while back by ios 17.3.x.
tried removing and re-adding the radius server without success ( I suspect the upstream switch was offline of the time of startup, however the radius deadtime which should default to 0 to trigger it back online is awaiting infinity)#BeforeRADIUS: id ...
