Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently upgraded my Cisco ME environment to 8.10.142.0, 3802 and 2702 APs. Apparently, when I did that my Ring Doorbell and Stick Camera both stopped associating to the network. I was unaware until a week ago I tried to view them and their battery...
Finally was able to figure this out after much research between cisco and ring. The issue was having 802.11r on the WLAN, although it was set to Adaptive. I had to create a new WLAN and disable 802.11r. Now the Ring doorbell is connected and working ...
Yes as well as deleting my current one and recreating it. Neither one worked. The only way I can get the ring devices to join is if I have an SSID with open authentication. That is an obvious issue.
Aaron,Has firmware 1.4.3 been submitted for FIPS approval yet? As you may know, until this is done and approved, this is going to be a challenge in the Federal Government.
