Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an issue whereby I import a floor plan into WCS and then open the map editor and draw over the map the wall obsticles so as to have the heat maps and RF predictions reflect the attenuation characteristics of the walls.I save the map and at a l...
I have need in the map editor to tag a wall as having an infinate DB loss when predicting RF heat maps. The rooms in question are operating theatres and as such are lead lined as part of ratiation shielding for mobile X-Ray equipment. I am placing 11...
I have deployed a WLAN utilising 9 1142 N AP's controlled by a 4404 WLC. The system works fine at 2.4Ghz, but for the life of me I cannot get a connection at 5Ghz using 802.11N. The a/n radios appear to be enabled, I have followed the info in the 114...
No mention of the number of obstacles. I too am very detailed on my map layouts. The only thing they came back to me was that I may have been inaccurately drawing the obstacles by not magnifying the floor plan enough. This was a bit of an insult.I ha...
No, never have resolved the issue. I have had a call with the TAC for a month or so now, they cannot duplicate the issue, so I have basically given up on a solution. Looks like I will have to wait for the new version of WCs to be released next year.....
In addition, I have turned on the SSID broadcast whilst fault finding. If I turn off or disable the 802.11 b/g/n (thus I assume the 2.4Ghz) transmitter, I cannot see the broadcasted 802.11 a/n SSID.
