Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, we have a couple of AP1262N-E-K9 APs with firmware version 12.4(25d)JA1 operating in autonmous mode. One AP is setup as repeater while all others are in root mode. My goal is to perform the antenna-alignment test through an SSH console on the ...
Hello, we have a couple of AP1262N-E-K9 APs with firmware version 12.4(25d)JA1 operating in autonmous mode. One AP is setup as repeater while all others are in root mode. The repeater has setup one parent MAC address so it associates every time to th...
Hello, we have a couple of AP1262N-E-K9 access point with firmware version 12.4(25d)JA1 operating in autonmous mode. I attempted to measure the signal quality between the APs by setting one device to repeater mode while all others are in root mode. T...
Hello, we have purchased a couple of new Aironet APs for our office:AIR-AP1262N-E-K9My objective is to use some of these as wireless monitors to scan the vicinity and to report the SSIDs and RSSI values of all detected APs.Basically something similar...
Thanks Scott. As far as I know, you need a service contract for opening a TAC case. We don't have a service contract. Moreover, this behaviour appears to be a bug in the Cisco firmware which affects any customer using this command with this firmware ...
Indeed, the config analyzer seems to be a valid solution:https://supportforums.cisco.com/docs/DOC-1242However, for some small deployments, it might be too expensive to get a WLC so it would be nice to have a stable method of scanning adjacent APs whe...
It depends on the following question:When using a WLC and lightweight APs, is it possible to measure the received signal strength between the APs?It appears to be possible to measure the signal strength of clients connected to the AP. I haven't found...
Dear Scott,thanks for the suggestion. It's probably unclear why I am going through all this trouble. So I will try to clarify:Why do I set up repeater mode and perform the antenna-alignment scan? Because it's the only way to perform the antenna-align...
Thank you for the reply. I assume Cisco intended to only use the antenna-alignment command once in the setup phase and not periodically via remote ssh sessions. Still, that's what I am trying to achieve. I have some new insights: Problem 1) is only a...
