Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So I got a old cisco 1921 router off ebay that was said to be ready to go and this is my 3rd exhausting day trying to bypass the old companies security on it I HAD so many hours today already im just exhausted I have tried hundreds of times.. here is...
HELLO ALL!!!! Guess who beat the 1921 router! ME! and nobody here was actually correct the way I got past this was by not using a console cable at all. I had tried 3 different console cable on it and none did it but you know what did the micro usb...
From my reading here: Cisco configuration guide.. link had to be removed.........Recovering a Device from the No Service Password-Recovery FeatureTo recover a device once the No Service Password-Recovery feature has been enabled, use the telnet clien...
Ok.. so here it is.... I have 2 more of these same routers.. WORKING... is the IOS and configuration separate? I'm talking of puling flash from one into this one just to break past it but if this lock is on the flash alone then that's out. If so ...
Id think Id be able to handle it to be honest.. As I say there are many different ideas on where the right spot to hit the break is.. I'm convinced its deeper than just my ability..
And as I said id try it again no luck as usual.. I waited for the ok and first time hit the key for break and 2nd time used the meu option on break all of the times it never really stopped just carried on as normal and ended up at unsername question....
