Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,My 3602 running 15.3.3JF12i will only broadcast on 802.11N over 2.4G only. The config I have is: dot11 ssid LM0701band-selectauthentication openauthentication key-management wpa version 2guest-modewpa-psk ascii 7 xxx-snip-interface Dot11Radio0no ...
All of the Wi-Fi clients -- 4 x iPhones (XR or newer) + 3 Lenovo (X1, T460 & T480 all running latest Intel WiFi driver) have no problem to connect to a 802.11ac AP (Netgear Night Hawk). I did disable 802.11n 2.4G radio on the Cisco 3602 explicitly –...
Thank you -- I have since tweak "dot11 band-select parameters" and it has done the trick. The 802.11ac interface seems to having same problem. I can sure use some helps to troubleshoot. Attached is output of "sh controllers dot11Radio 2". Are ther...
Pls see the outputs from attached file. Note I am seeing same problem on two separate 3602s - one with 802.11ac module and one without the 802.11ac module. I have "wr erase" and use CLI to rebuild both of them from scratch. However; the problem pers...
