Hi, Just wondering if anyone else has seen this behaviour ....When I use ASDM or the CLI to copy (ftp) files from my management station to flash on my ASA5520 I get to 99% and then the gui or cli window hangs.The ASA itself completely free...
Got an ASA5520 running V8.2(3) and we want to upgrade our internet bandwidth. Our ISP says OK but we need to install different physical circuit,upgrade CPE router, etc.Then they say, btw your globally allocated IPs will change - this is a problem as ...
Hi, Running V8.2.(2) on an ASA5520 and I'm trying to configure dhcp servers on vlans.Is this actually possible or am I just misreading the Command Reference ?I can configure the VLANs sub-interfaces fine (IP address, netmask, vlanid, nameif, ...
I tried to upgrade my ASA5520 from V8.2 to V8.3 last week and although the log reported no issuesthere obviously were 'cos a some of my NAT mappings stopped completely (!)I was unabled to complete a fix within my upgrade window so I had to rollback...
Hi, I'm looking for a general steer / experiences in implementing this using an ASA. Colleagues are steering me down a route of Microsoft ISA to provide thisfunctionaility.I kinda hope I can just use the ASA. Many Thanks,
Hi Avinash, Well, I got this working by ditching the ASDM and using the CLI to get some sensible error reporting.The DHCP address (pool) has to be well within the IP address range specified on the (sub) interface and that's even takin...
Hi Andy, Thanks for the reply !Yes, my inclination is to go for option a) 2 insidei/f with the same security level connected to 2seperate switches (4500s) and use OSPF routing oneach PIX. The 4500s are interconnected via 2 ISLsfor redundancy p...
Hi, Well I eventually got around to trying this method on my PIX (sorry it's taken so long).The access-list 100 .... is OKThe global (outside) 60 a.b.c.d is OKThe nat (inside)60 access-list 100 a big no-no6.3(1) does not allow this, C...
Hi, I'm looking to hide the internal IP addresses behind a mutually acceptable IP range. I want touse something from rfc1918 (private IPs) as atransit for the site-to-site link.If I were using IOS, I'd use ip pool, access-lists and nat statements ...
