Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We recently replaced 3750 switch with 9300. From the day one, I'm having an issue with various different things like https doesn't work to hosts that are connected to this switch. I can't seem to ping anything bigger than data size of 1372. The sw...
Hi,I'm trying to figure the issue I'm having with a P2P circuit between two of my sites. They are connected by two 6509s. It is a simple config. switchportswitchport trunk encapsulation dot1qswitchport runk allowed vlan 220switchport mode trunk Th...
Hi,I'm trying to configure my first Firepower 1010 replacing Fortigate. Few things I'm stuck at the moment.1. How can I configure dhcp options like 150? I don't see that options anywhere in the FDM gui. 2. Is there anything like software switch fe...
I was able to resolve the issue after spending hours of troubleshooting. It turned out the issue was with MTU settings. I had to issue "system mtu 9198" on the new switch. I looked at the old switch and it was running system wide mtu 9198. Once ...
Thanks for your reply. Nothing has changed on SP side, everything was fine with the old 3750 switches. All the issues were started after we replaced with 9300. I don't think the issue is with SP. I just opened up a case with Cisco, also. Hope th...
Thanks for your quick reply. I was reading about FlexConfig. I'm little confused on FlexConfig. How do I use FlexConfig? Is it from CLI? I'm sorry if I am asking a stupid question. Thanks for your help.
