Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all:
I am having an issue with a 1:1 NAT on an FTD. I have two FTDs (both managed by an FMC), and they both have 1:1 NATs. The NATs are working on one FTD, but not on the other. They have different flavors of internet, and the problem is relate...
Hi all:Here's the list of route priorities. Does anyone know where Source-based Default Routes fall?Directly ConnectedClient VPNStatic RoutesAutoVPN RoutesNon-Meraki VPN PeersBGP learned RoutesNAT*I'm guessing between 6 and 7, but I can't find a sol...
I have a very strange scenario, and I am curious if anyone has experienced this or has some insight.I deployed two MX95's in warm spare. There are no other Meraki appliances (MS or otherwise) in this network. They're connected to a Nexus switch, bu...
Hey all:Say I have these two objects:Object1 = 192.168.1.0/24Object2 = 192.168.2.0/24Say I have an MX64 with two VLANs:VLAN1 IP = 192.168.1.1/24VLAN2 IP = 192.168.2.1/24Say I don't want these subnets to talk to each other. Could I make an object gro...
Hey all:I'm planning to swap out an existing non-Meraki device with an MX95. Some of the devices behind the existing firewall have public IPs. The internal interface on the existing router has a public IP also, and that's how those devices get out ...
I have an update on the issue. We moved the devices (WAN and LAN ports) off the fabric extenders and on to the switches that the extenders connect to, and now the issue isn't happening anymore. I can reboot either MX without the connected switchpor...
Thanks for the reply @Ryan_Miles. I do have some packet captures we took from the Nexus as I rebooted one of the MX appliances. I attached it to my Meraki support ticket if you want to take a look. There are BPDUs in there, but I'm pretty sure tho...
Thanks for the reply.I didn't think of that. Have you done something like that before? I just assumed that the dashboard wouldn't let me configure a 1:1 rule like that.Edit: I did some digging on this. The dashboard let's me configure the same ad...
Thanks for the quick replies all! That's too bad that I can't block that from the firewall page. That seems like the most logical place to me. I tried applying a group policy to the client and that worked as expected. Another reason I wish the "f...
