About joenyland

joenyland · 12-11-2012

I've just purchased a new Cisco 881.I'm using NAT NVI for my inbound static mappings. However, regardless of the fact that the config is saved to nvram, after a reload of the router, the NAT mappings are setup as traditional inside/outside mappings. ...

joenyland · 12-28-2012

Elton, thanks for the continued inout and I'm sorry for the delay in replying.The grouped interface that you mention are not available as far as I can tell on the 881/891's, at least. You'll notice from my configuration which I provided in my origina...

joenyland · 12-13-2012

Thanks for the suggestion Elton.Unfortunately, I believe the LAN ports on this router are layer 2 only, thus they will not take `ip nat` configuration:Router1(config-if)#ip nat enable ^% Invalid input detected at '^' marker.Route...

joenyland · 12-13-2012

Sorry, the config included in my original post was a little out of date. I've updated the NAT section of the config above with the mappings that I have setup on the router.The topology is pretty simple: 192.168.1.0/24 Vlan --> Cisco 881 --> ADSL mode...

joenyland · 12-13-2012

No one any ideas?

Member Since	‎12-10-2012 01:59 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

Cisco 881 loses NAT NVI mappings after reload

Re: Cisco 881 loses NAT NVI mappings after reload

Cisco 881 loses NAT NVI mappings after reload

Cisco 881 loses NAT NVI mappings after reload

Cisco 881 loses NAT NVI mappings after reload