Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am not sure if there is a bug fix for this or not, or even how to apply a patch to the CSC module. Our problem is when we configure any URL blocking or URL filtering, it seems that the CSC module crashes and none of the web traffic can procede ...
Hi, I am trying to setup a Cisco ASA firewall. I have attached a diagram of what it needs to do.I have managed to get the ASA to do the nat /pat (many inside to one outside address) traversals to work, but I am running into a problem with getting the...
Hi, I am trying to setup a Cisco ASA 5510 (with plus) to act as our main firewall as well as offer us DMZ services, for webserver/SSL Concentrators (Citrix and Cisco CVPN3015). What we would like to do is a dual homed DMZ, where one link is for the ...
Hi,I am wondering if there is a bug in the latest cisco firmware for the 871 routersc870-advipservicesk9-mz.124-11.T2 .We noticed a major problem since upgrading from c870-advipservicesk9-mz.124-4.T3, in that it wont allow us to set a qos service po...
Hi, We have a bunch of Cisco 871 routers and after upgrading to the latest IOS (c870-advipservicesk9-mz.124-11.T2.bin); do to some of the problems with previous IOS versions (appfw consumming 100% CPU); we are experiencing a problem with 1 of the rou...
This seems to work for the pings. Thanks. What would the access-list / group look like to allow for traffic from the dmz-inside to the inside interface ?
seem to be having a issue with pinging anything outside (aka ICMP traffic seems to be denied right now). Anyways, here we go. PS: we also are using OSPF on the inside network. ASA Version 7.1(2)!hostname firewalldomain-name example.comnames!interface...
I can ping from the inside interface to the inside DMZ interface now, but can't do it in reverse. the same-security-traffic permit inter-interface didn't seem to help anything ..
does the static command mean access list permissions / routing permissions, or does it have something to do with NAT. I don't want to use NAT on the DMZ .. thanks
Hi Andrew, This is the conclusion i have come to aswell. I am trying to figure out how to get the routed mode to work right now and it seems there is something i am doing wrong, as data just wont route across the interfaces, even when setting the acc...
