Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I have just been setting up a WISM2 in a test lab and for some reason the Supervisor is not creating a port channel on my 6500 as suggested in the WISM2 Deployment Guide. WISM2 is installed in an appropriate slot (according to same doco) and...
ok.. so i figured out what was wrong. I had forgotten to trunk the supervisor vlan and set the native on the controller...wism module 3 controller 1 native-vlan xwism module 3 controller 1 allowed-vlan x-y
