Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know why the interface is showing "reset" for layer 1 on a serial interface? I have removed the interface from the T1 controller and setup the interface again and have no cable plugged into the port, yet the device still states layer 1 is...
#sh int s2/0:0Serial2/0:0 is reset, line protocol is down Hardware is M32X with CSU/DSU MTU 1500 bytes, BW 1536 Kbit, DLY 20000usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation HDLC, loopback not set Keepalive set (10 sec) ...
Hi gopikrishHave you checked the messages from the other router when you initiate the #clear ip bgp *If you executed the command from the other router, it would initiate the request and your messages source and destinations would be different.Output ...
If you have the same WAN encapsulation on the interfaces you can run #debug interface serial this should give you a myseq/mineseen/yourseen seq number for layer 2 transmissions.
