Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning, CSC.Is there a way to load a spare compact flash with a running-config, ASA IOS, & ASDM software via card reader? I need to load another flash card with all of the settings necessary for normal operation. This "spare" card will replace ...
Good morning.A recently added outbound rule has left my SMTP communications broken. I have since removed the rule, and had Cisco do some damage control, but it's still dropping some of the SMTP traffic. I get a number of NDR messages each day like th...
Is there a way to factory-reset a Catalyst 3500 XL, without using commands? I.E.: Dip switches or reset button inside/outside the case? If not, I do not have the enable password and need to reset it and all VLAN's back to factory. Thanks in advance.S...
Hello.Recently, I've been having significant problems with denial of service on our ASA-5510. Two IP addresses in particular attack my ASA regularly. What kind of rule do I need to create to deny these IP's access to my firewall?Thanks!Sent from Cisc...
Hello,I need to upgrade the compact flash of my ASA 5510 from 256MB to 512MB. A friend's recommendation was to buy a card reader, copy all of the data from the existing card and paste it to the new compact flash. I have a hard time believing that it'...
Collin,Did a low-level format. Same result as before. The ASA Flash LED lights up (on the ASA), then goes dark. In the ASDM, File Management still shows Disk0:. CLI dir /all still shows Disk0:.Any chance this flash is defective or incompatible with m...
Collin,Below is the dir /all output:Result of the command: "dir /all"Directory of disk0:/101 -rwx 5511168 19:06:34 Dec 31 2002 asa707-k8.bin6 drwx 8192 04:30:18 Oct 18 2007 crypto_archive102 -rwx 6161700 04:32:52 Oc...
Collin,Please forgive the ignorance to follow...1) When I went to install the 512MB card into the ASA, I found the CF port empty....no 256MB card there to be found. It must be onboard memory, I take it?2) After installing the 512MB card, I logged int...
