Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm doing a simple practice lab. The lab is designed to not give you all the information you need. I am trying to do a lab a day in preparation for getting my CCNP. (Still a ways off) This is also my first experience with CML and the IOSvL2 nodes. I'...
For anyone wondering, I found the problem. I did not configure encapsulation mode. After configuring dot1q for all active ports, root bridge is now on a single switch as it should be. Never give up!
I've redone this lab over and over, with the same result. All switches consider themselves the root bridge for VLANs 100, and 200. VLAN 1 behaves normally in regards to STP. Note: balaji.bandi was wrong about me not having VTP configured. VTP config...
I configured VTP domain, password, and version on all switches. If I hadn't, then how would the VLANs have propagated to the other switches. I only configured VLANs on DLS1. It seems like I am possibly running into a glitch.
