Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,recently installed the AP 350, and can work properly. But today, I cannot see the status of the radio, only ethernet port is UP.Therefore I can't use the wireless client card at all. No signal at all.How to solve the problem?TIA,Andi
Hi,Thank you very much for your kind help.BTW I've contacted cisco technical assistant, and she confirmed it's hardware(radio module) problem. I'm lucky because this AP is still under warranty, so they'll send me a replacement. Regards,Andi
Hi,additional info about the status light.1. The ethernet is blinking green (normal)2. The status is blinking green 50% (normal)3. The radio is off (normal) because no client is active.Rgds,-andi
Hi,Thanks for the information.I opened the setup webpage of AP, then choose Setup.Under Network Port I can only see Ethernet. No Radio.Why is the radio disappreared from the setup ?Is it because hardware problem?Please help.TIAandi
