Hello,2600----7507--cip-------------------MainFrame | | (dlsw)----TokenRing----3745 -------- Suppose, when remote SNA device want to connect to mainframe through DLSW, CIP reponse should be faster than...
Hello,In my customer site, SDLC device connect to 2600. IOS version is 12.0.7T. Then access AS400 through DLSW function. We showed log and found the connected interface down very often. show log as below.We checked AS400 log and didn't find the SDLC ...
Hello,ATM device---modem---modem---2600 router -----7500 router ---HOST2600 connect to modem with RS-232 DTE cable.We see dlsw cir is connected, but it dosen't work well. It disconnects very often. After we change cable to RS-232 DCE cable to modem i...
My user set up 5 stun addresses in a stun interface. And totally there are more than 1000 LUs in the interface. Every LUs session response time is more than 7 seconds. Is it normal?? We want to know how many LUs and PUs I can set up in a stun interf...
Hi Ed,There are SNA gateway and AS400 in on the Fa4/0/0 and need to be bridged into CIP or TR6/0/0 interface.So we need translation bridge. By the way, I am not sure why has "bridge-group 1" configured under the TR 6/0/0, I would remove it and try.Ve...
Thank you for your reply!!TokenRing and CIP are in the same 7507 router.Remote dlsw connect to the 7507 router, then go through CIP or TokenRing to Host.Bus as I know, CIP speed should be faster than TokenRing. Why the explorers from TokenRing side g...