Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
-I'm trying to configure a interface loopback under default vrf Mgmt-vrf and the follow log appears:
%IOSXE_MGMTVRF-3-INTF_ATTACH_FAIL: Management VRF attach to mgmt loopback failed%LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback10...
Hi Folks, We build a IPSec tunnel from a router remote site to ours central site router. We have a corporate Firewall (ASA) protecting our central site... To acomplis this task we made on ASA a one-to-one Static NAT and a inbound access-list permi...
Routing Table: Mgmt-vrf
Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGPD - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter areaN1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2E1 - OSPF external type 1, E2...
Interesting... not showing any interfaces associated with the vrf:
Switch#sh run | sec vrfvrf definition Mgmt-vrf!address-family ipv4exit-address-family!address-family ipv6exit-address-familyvrf forwarding Mgmt-vrfvrf forwarding Mgmt-vrf
But if i do:...
Thanks a lot for your help Rob.And the fact that we are opening inbound port´s for the remote site IP inASA:access-list outside_access_in extended permit udp "Remote_Site_IP""central_site_IP" eq 4500access-list outside_access_in extended permitudp "R...
