Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Evening,Perhaps some of you fine folks can help me stop banging my head against a wall.I have an ASA 5505 running 8.2(1), that is configured with three interfaces as follows: Inside (security 100) 10.0.0.0 /24 Inside 2 (securit...
I'm transitioning from a Netscreen 50 to an ASA 5510. Trying to re-establish the few VPN tunnels that I have. On the old Netscreen, rather then using a IP address for the far end of the tunnel, it uses a "PeerID" (the other end of the tunnel gets it'...
Good afternoon!Maybe you fine folks can help me - Trying to add another subnet to internal network (to eventually transition to this new subnet). Going to use VLAN's for this, but don't know how to create a VLAN and have it route to the existing netw...
Jon,I think I understand what's going on here, except for one thing:The crypto map (not dynamic) uses the peer ip address and pre-shared key to authenticate the peer. I have this for the peer:(123 is my example peer IP Address)crypto map Outside_map ...
Jon,Thanks for all the help!Various outputs exceeded the limit, they are in a .txt attached.I'm using the following to test connectivity:on the 10.5.0.0 Side, a machine with the ip of 10.5.0.3 w/ a gateway of 10.5.0.2on the 206.97.124.0 side, a machi...
