Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking at implementing Port Security on our Cat 5500 by using the set port security <port range> enable. The way i understand this command to work, it will make the switch learn the MAC addresses of the devices already plugged into those ports...
I am having an issue with a Symbol Spectrum 24 High Rate client card connect to the Cisco 1200 AP. The error I receive on the client software is, 'Network out of range'.I was able to configure a Linksys card to communicate with the 1200. Any idea?
"You need to set up a user with user name and the password as the MAC address in the format of xxxxxxxxxxxx." Will this work with Cisco ACS version 3.0? I tried entering the client MAC address into the ACS, but it came back with an error saying 'Can ...
So if I unplug a device for the 15 minute countdown +10 seconds, the switch will clear the MAC address out and be available for a new device to plug in? If this is true, then I could set the timer to 0 minutes and lock a port to that MAC unless it wa...
