About Alexander_Wilson

Alexander_Wilson · 12-03-2009

I'm trying to get an IPSEC VPN up using CCA 2.1. I noticed in the console window this after attempting to create the VPN2009.12.03-03:42:04-PST INFO isATMConfiguredForPPPoAandPPPoE() for ATM02009.12.03-03:42:04-PST DEBUG isATMConfiguredForPPPoAandPPP...

Alexander_Wilson · 11-11-2009

Hi folks. I'm new to this community.I have an sr520 router/dsl modem combo device that I configured via the CCA. I had all of its configuration set (so I thought) until I plugged it into the ESW500 switch.It said it had not configured the proper swit...

Alexander_Wilson · 12-03-2009

I should add towards the end, we have this:2009.12.03-03:42:04-PST INFO isATMConfiguredForPPPoAandPPPoE() for ATM0.12009.12.03-03:42:04-PST INFO isConfigured() com.cisco.xdm.data.interfaces.Dialer2009.12.03-03:42:04-PST DEBUG isConfigured(): Returnin...

Alexander_Wilson · 11-13-2009

Ok, so I said I'd post the full information and here it is.My IP setup is 67.118.230.193/29, gateway .198. Physical topology:DSL modem/router (SR520) -> ESW 500 switch -> all my systems/wireless67.118.230.193, internal to 192.168.0.50, switch @ .250,...

Alexander_Wilson · 11-12-2009

Hi Bill.I thank you very much for the response.Here's what happened - as soon as I set the 'router' type on the port, I lost full communication to the device. I did it again (off the switch) as a test, only I was prompted for which vlan - I took 75. ...

Member Since	‎11-11-2009 10:51 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	8

User Statistics

User Activity

SR520 + IPsec VPN, and the negoiated IP.

SR520 - DSL, PPTP, and the ESW500.

Re: SR520 + IPsec VPN, and the negoiated IP.

Re: SR520 - DSL, PPTP, and the ESW500.

Re: SR520 - DSL, PPTP, and the ESW500.