Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team, I was wanting to create guest SSID using RESTCONF interface on Cisco WLC 9800 Controller. I made use of yangsuite module that generates REST API and wrote a python script and the error message which I see upon execution (both attached).
...
Hello TomTry this and see if it works:Power off the ServerRemove the display connectionPower on the server, wait for 15-20 secondsPut the display connection back and see if it goes beyond the Cisco splash screenThere is a known issue with C2XX server...
You dont have to specify capability command in SV1(2) code.By specifying port-profile type ethernet UPLINK_ALWAYS you have already configued the port-profile to be capability uplink.
In 4.0(4)SV1(2)....you need to specify type ethernet which is same as using capability uplink in the SV1(1) code, so you would do :N1KDEMO(config)# port-profile type ethernet system-uplink-control-packet If you do not specify type ethernet it will de...
Absolutely...without vCenter you cannot add Hosts to the DVS,you cannot assign NICS to the port-profile,also vmware features like vmotion/drs will not work as those are vCenter triggered operations.However if your vCenter crashes/fails after the host...
Looks like you have tried to register a plugin that was already registered.You may want to go to the Troubleshooting Guide (downloadable from http://www.cisco.com/en/US/products/ps9902/tsd_products_support_series_home.html) and on page 3-11, there is...
