Hello!Can you please help me - I try to interop VCS-C and CUCM following Cisco_VCS_Cisco_Unified_Communications_Manager_Deployment_Guide_CUCM_6-1_7_8_and_X7-0.pdf but it not works in both ways. When I try to locate CUCM nomber (77xxxx) on VCS-C, it t...
Hello!Could you please tell me, when CISCO starts officially support Lync2013 - release a new software for VCS-C and documentation on integration?The primary interest is in the possibility of transferring video between CISCO endpoints/MCUs and Lync o...
Hello!Could you please help me?What should I do to host the presence information of my SIP domain not on local VCS Control, where the endpoints registered, but on the VCS Control located in neighbor zone ?
Hello!Could you please help me with correct B2BUA settings?Now I am trying to migrate from direct SIP trunk to Lync in VCS X6.1 to B2BUA application on VCS 7.3 fully following "Cisco_VCS_Microsoft_Lync_2010_Deployment_Guide_X7-2" and ran into some pr...
Hello, Tomonori!As I described above, there is a search rule on VCS-C that transforms 77xxxx@vcs-sip-domain to 77xxxx@cucmip and places a call to CUCM zoneAlso there is a transform on VCS-C to convert xxx@cucmipaddress:5060 to xxx@vcs-sip-domain Ther...
In my environment this does not works from the moment when I installed Lync2013 client (even in Lync2010 pool). I've tried to call from Lync to H.323/SIP registered endpoints and H.323/SIP registered confs through global scope static route in Lync to...
Hello, Andreas!Thanks for your answer.Yes, it's ok when using amgw - video works two-way(RTVC1 with Lync and H.264 with telepresence), but maybe there is some problem with signalisation: video-call establishes correctly only when calling from telepre...
Hello, Andreas!Thank you for answer!I am aware of the negative impacts of static routs, but it's more convenient to me for the moment.I will open TAC case and provide debug logs.Best regards, Evgeny.