About joel.hendrickson

joel.hendrickson · 09-20-2016

The configuration manual for this device says for configuration to log in using the console. When I begin the configuration I insert the new name and it asks for a password. It will not take any password, the cursor remains stationary no matter what...

joel.hendrickson · 09-21-2016

Yes, show version works fine in the User EXEC mode. The version is C1530 software (aplg3-K9W7-M), Version 15.3 (3) JA8, RELEASE SOFTWARE (Fc1). I am looking for any way to see what the antennae mode is in. I have purchased this AP to replace an old ...

joel.hendrickson · 09-21-2016

This command will not enter into this access point via command line. I have tried many times with all privilege levels. Are you sure there isn't a new replacement command for this?

joel.hendrickson · 09-21-2016

Thanks Brandon, I was finally able to get the autonomous image to download. Does this include the single antennae mode or do I have to go in and switch from dual to single antennae? Also shouldn't the privilege exec mode allow for any and all comma...

joel.hendrickson · 09-20-2016

the "capwap ap autonomous" must be wrong. It doesn't like the a in cap.

Member Since	‎09-20-2016 12:14 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	6

User Statistics

User Activity

AIR-CAP1532E Access Point Initial Configuration

Yes, show version works fine

This command will not enter

Thanks Brandon, I was finally

the "capwap ap autonomous"