Hi Everyone,BGP (Wan Site) is the production internet which are working properly now.We would like to setup Vlan HSRP with Primary and Secondary IP subnet on Vlan 172 route to Wan Site (BGP) on VRF setup the static route interVlan 172 Primary and sec...

Hi All,  Site A <BGP protocol> Backup Site B We did the scenario of Stacked Site A whole switches 9300 are down and backup site of Stacked Switch 9300 did not pick up on it because the subnet of switch gateway vlan IP (Vlan 221) on Site A which is no...

Hi All, We would try to make a EtherChannel (LACP) on Te1/1/1 Switches (9200) From Main site to backup site.However, it shows up have this error "suspended: LACP currently not enabled on the remote port." Although we add Channel-protocol LACP on back...

Hi All, Currently, We checked that we did not use portfast and bpduguard on access ports, configured the trunk ports (etherchannel and internetwork(metroE) with Rapid PVST spanning tree setting between Main site and backup site. We found the Loop and...

Hi, We used default of Spanning Tree RPVST on 2x C9200 in Primary Site and Backup Site and would like to use these more effectively to prevent the STP loop and single port loop. We would like to set this followed STP Root Priorty Primary and Secondar...