Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm currently running tests on my standby unit and once done would like to sync the test config to my Primary ASA. Is there a simple way to make this happen?
I have the following static entries in my firewall. One works and the other doesn't. I just added the second entry below today and I see it build in my logs but no connection is established to the remote end. static (inside,ICS) 192.168.50.97 192.1...
My primary power failed two days ago and I am now only running on failover. Many of my static translations are no longer working and i cannot figure why since the configuration looks correct and I have confirmed each of my connections are mirrors of...
I can see the connection being built but my Pix 501 will not complete the active connection to the inside network. Is there anything wrong with my config see below. I have tried almost everything and still no connect.PIX Version 6.3(5)interface eth...
I'm not seeing any acsls but the gateway question does make me think of something that we had to do as a workaround many moons ago. It could be as simple as a route that I've had to manually put in place. Thanks for that question.
Jon, The static statements match our physical configuration and we are simply trying to connect from host 192.168.50.9 to translated addresses that connect to both 192.168.80.97 and 192.168.80.14.The connection works and I'm fine to 192.168.80.97's t...
Right now I have the remote system and the PIX on a switch while the rdp host is directly connected to port 1 on the inside of the firewall. If I place the host and the rdp server on the switch i can RDP with no problem. Just cannot get anything w...
