Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What version of the IOS do I need on a 1760 to support the dlsw and source-bridge commands? I'm currently running c1700-sy-mz.122-11.T2.bin (IP Plus), and it does not support the commands. Do I need to take it to the IP/ADSL Plus for these comm...
Whenever I activate my DDR line it connects just fine until I try to send traffic across it. Then it disconnects the line. Config and debug below - any help would be appreciated.service timestamps debug uptimeservice timestamps log uptimeservice pa...
I've got a customer using a 3660 connecting to 11 sites using a combination of point to point and frame-relay connections. Each of the remote sites has a router installed with a WIC-T1, and an ISDN module to be used for backup. My goal is to have t...
If there was already a NAT translation in place when you implemented the ACL, you may need to clear the existing translations.clear ip nat trans *the ACL in your snip should exclude traffic coming from 192.168.0.10 to 192.168.7.17 from NAT and NAT ev...
If everything is there except for joining the domain it could just be a simple WINS problem. Might be worth double checking WINS settings on your remote network workstations to be sure they are pointing to the WINS server on the main network. LMHOS...
Your configs look fine for the tunnel from what I can see. I assume the workstation that your trying to ping doesn't have problems or a software firewall preventing it from replying (XP sp2). If you had built the configs and tried immediately, its ...
