I have the following scenerio. Outside interface address of pix 10.10.10.253 and Inside interface address of pix 192.168.120.253. If I do the following:global (outside) 1 interfacenat (inside) 1 0.0.0.0 0.0.0.0 0 0global (inside) 2 interfacenat (ou...
Can I use IDS MC v1.1 to manage both IDSMv1 and IDSMv2? I can setup all the IDSMs but when I try to look at the signatures, I see nothing for both IDSMv1 and v2. In addition, I do not see the filters that were setup on the IDSMv2.Thanks
Any idea how to fix the following error?Error: ct-sensorApp.1135 not responding, please check system processes - The connect to the specified Io::ServerPipe failed
Hi, I just use VMS to upgrade some of my blades to the newest signature pack. After upgrade, two of the blade is no longer accessible via ssh. It would go through the process of loggin in but after putting in the password it just hang. Anyone ...
Hello, Has anyone tried to use the "automatic update" function on the IDSM? I created what appears to be an "AT" job on the blade but the job never kicked off at the specified time. Anyone have the same problem? or get it to work?Thanks
Try adding in the following line under flexconfig with the rest of your netflow configurations.flow-export template timeout-rate 1 These are my flexconfig on my firewalls using CSM:access-list global_mpc extended permit ip any anyclass-map glob...
The IPs are different. But here is a config of what I am trying to accomplish on my test PIX.PIX Version 6.3(3)107 interface ethernet0 100full interface ethernet1 100full interf...
4.1(1).S50. With help from Kevin W., I was able to fix my issue. I disabled sig 1200 therefore my SensorApp would not start. I was able to re-enable the signature through service mode and my IDSM is working again.
