Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i am configuring bandwidth shape for switch 2960-l i want to configure limit bandwidth for port 3 and 5 is 15mbps but it still not working please help me to solve this problem. total_test(config)#mls qostotal_test(config)#interface gigabitethernet 0/...
Currently, I receive requests from my superiors to deploy network systems for my companythis is my first time to use SWITCH MS410, please guide me step by step to configure this SW l3 to suit the requirementsLook forward to your help.
@Joseph W. Doherty thank you very much. I make sure that QOS has been enabled, i tested it and it was running on the second queue total_test(config)#mls qos total_test(config)#interface gigabitethernet 0/5 total_test(config-if)srr-queue bandwidth ...
Thank you for help me.I have configured as you instructed but the network speed is still unchanged(total_test(config)#interface gigabitethernet 0/5total_test(config-if)srr-queue bandwidth shape 6 0 0 0).
@Joseph W. Doherty Your gig interfaces are running at 100 Mbps?->running interface is 1000mThe traffic you wish to shape is directed to the first queue?->yes i want to go to the first queue?
