Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I restart Aironet 2802i that's powered by SG300-28PP 28-Port Gigabit PoE+ switch, I see the following message:
[*09/26/2016 13:47:31.8044] Radio0 not started, not enough POE power
[*09/26/2016 13:47:31.8173] DOT11_DRV[0]: set_channel Channel set...
Hi, I have 3 Aironet 2802i where one of them is configured to run Mobility Express.
I created a guest network, and when a mac OSX (10.11.6) client joins, I see following pop-up from their web browser. Any suggestions on fixing this?I don't see any o...
We have three Aironet 2802i, where one of them is running Mobility Express. (One of them seems to have hardware issues so we are getting one replaced, but that's a different story..)
When configuring a new WLAN on a Mobility Express, what is 'Admin ...
'show ap config 802.11a summary' and 'show ap config 802.11-abgn summary' shows that the radios are all enabled for both of the access points that we have in the cluster. thanks!
Apparently Aironet 2802i has different set of commands..
'show interface' requires a parameter, and 'show interface summary' or 'show sysinfo' doesn't mention anything about the radio.
Which controller are you using? Is it an Mobility Express contro...
I think the message might be red herring actually. I am seeing this message towards the end of the boot sequence, and when the AP actually comes up, I can connect to it. Unless there are more than two radios, then they are definitely up and functio...
I don't think the command 'power inline static max 25000' can be run. Here are the options:
switcha6ae68(config-if)#power inline
limit The port limit of the interface from the point of view
of inline power ma...
