Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!I've recently installed a Cat3550XL running IOS release 12.1. This switch doesn’t seem to recognize the "Port Monitor" command. Anybody knows the new syntax?Thank's
Hi there!Is it possible to set up ip policy routing on an interface (using the route-map command matching an ACL and setting the next hop) and use the "standard" routing table when there are no packets matching the ACL? Or let's put it this way:If no...
Hi!I've got a Cisco 7200 VXR with a 12.3T IOS. This is what happens: I have a switch with 2 routers (Router A - the 7200 and Router B - one 3620) and one firewall. Router B has a static route to Network C via firewall. When a packet arrives at router...
Hi!I've got a G.703 (75 ohm BNC type) connected to a NM-1CE1U on a Cisco 3660 router. It's a 2mbps link. The controller keeps going down and them up again over and over. I contacted the telecom provider and they say everything is fine with the link i...
Hello you all!First off all, thank you for your time while trying to solve my problem…Well, I’m sure the provider has installed a unstructured G703 link. In fact, I even know it is multiplexed and put on a SDH fiber ring to the destination. I have go...
