Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This information isn't correct, and with these problems at no time should you have to reload the images or appliances in GNS3.If you have an exec command mode prompt "#" then you can do what you said below:switch# dir switch# show versionswitch# conf...
Try This Answer First Trust me this is much easier.The other accepted answer seems long and drawn out where you have to reboot GNS3 3 times and get a cauldron with frog warts and tears of a baby kitten, then reimporting your NX-OS, and rebooting GNS3...
