Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Georg,it's an old L2 switch (WS-C2960G-24TC-L 12.2(55)SE12 C2960-LANBASEK9-M). I was hoping to be able to do some very basic ipv6 routing with the dual-ipv4-and-ipv6 SDM template. However it seem like that's only supported with the lanbase-routing...
Were you able to figure this out?I'm facing the exact same issue, and am not sure if the switch actually supports routing (ipv6 unicast-routing command is missing).
